![revit 2011 menu bar not showing revit 2011 menu bar not showing](https://m.media-amazon.com/images/I/61Rwg6+sWzL._AC_SL1500_.jpg)
If the Wall System you selected has multiple UL Systems you will be asked which UL Systems to append to this wall type.Studs wider than 3-5/8” may result in better STC points.
![revit 2011 menu bar not showing revit 2011 menu bar not showing](http://www.scienceagogo.com/store/img-large/g/G6wAAOSwGiZhpn7X/s-l1600/Grille-Upper-Hatchback-1-6L-Fits-2011-2013-FORD-FI.jpg)
3-1/2”, 4”, 5-1/2” and 6” stud depths STC ratings are based on sound testing conducted on 3-5/8” stud depth.& 12”o.c. STC ratings are an interpolation of 24”o.c. STC ratings. All STC ratings are base on stud spacing of 24”o.c.Wall Systems that list STC ratings as "N/A" have not been tested yet.The STC sound icons can also be clicked on to simulate tones to help reference frequency differences between STC ratings. Click on the button in the Wall System column that meets your requirements (As shown below)įrom here you can also select on the UL or STC values for test report links and notes.If Design Type = Composite Wall, slide the Fire Rating and/or STC Sound Rating to wall requirements.Limiting Height - Slide ft (foot) and in (inches) sliders to required height.Lateral Load (Interior walls are typically 5psf).Select Design Type: (More on Which limiting height table to use).
![revit 2011 menu bar not showing revit 2011 menu bar not showing](https://cdn.vox-cdn.com/thumbor/kdBug3l6fnE3PcLeReaB29ky_S8=/0x0:1818x1186/1200x0/filters:focal(0x0:1818x1186):no_upscale()/cdn.vox-cdn.com/uploads/chorus_asset/file/23040590/GDC_Mathieu_profile.jpg)
The below options will help filter your selection down and then build your wall type. Once Wall Type Creator Add-In opens, selection filers will be preset to show over 500 wall systems. Click on ClarkDietrich Wall Type Creator ™.Click on Add-Ins in the Revit Menu Bar (See image below).
#Revit 2011 menu bar not showing install
Running this installation file will automatically install the Add-in into Revit® versions 2018 - 2021.Īfter installing the Add-In, open Revit in your project or in a new project. Installing ClarkDietrich Wall Type Creator:ĭownload the Revit® Add-in from the Autodesk® Revit® Exchange Store. ClarkDietrich Wall Type Creator develops information-rich wall types, with specific details on UL, STC, LEED and limiting heights.Īll information can be found in our web site Terms & Conditions page. ClarkDietrich Wall Type Creator add-In tool for Revit® 2018 - 2022ĬlarkDietrich's Wall Type Creator was developed for Architects and Contractors to run inside Revit Architecture or Revit Structural.